The SenSource PC-ME4 is an electronic hand tally with a 4.5-digit main display and two 4-digit sub-displays.
The tally has 4 selectable modes that are user settable by internal DIP switch position. Depending on the DIP
switch setting specific modes of operation can be chosen. Your PC-ME4 has been preprogrammed to operate as
a population counter (Mode 2). The unit has a built in buzzer that can be enabled or disabled by pressing and
holding the Reset button.
PC-ME4 Features:
Lightweight
Replaceable battery
Includes 22.4” (570mm) carrying cord
No mechanical parts to wear out
Beep at every count that can be enabled or disabled by pressing
and holding the reset button
Large LCD screen: 1 main and 2 sub displays
User friendly four programmable modes
Add, add/subtract, store memory, and rotate or shift display
PC-ME4 (electronic hand tally with a 4.5-digit main display and two 4-digit sub-displays)
OPERATION MODES
Simple Hand Tally – Add & subtract count, reset and memory storage.
Two counter Tally – Two tally’s, reset and selectable add or subtract
count with either tally.
Three rotating Tally counters – Three independent tally counters.
These counters can be rotated or shifted in a clockwise manner.
Multiple memory Tally – This is an add tally with a multiple number of
memories for storing count value. It has two operating modes, count
mode and memory mode. The user can transfer the displayed count
to a memory. Each time the user stores count values the memory
number increments.
Mode Section
An internal DIP Switch is available to select four different modes. Depending on the setting of a 2-bit DIP Switch a
specific mode can be selected. The PC-ME4 is shipped from the factory in Mode 2. The table here shows the
corresponding DIP Switch configuration. The operations for the UP, DOWN, R and S buttons are shown here for
each selected mode.
