» RX Unit - Watch Video
- Turn the RX unit on by sliding the power switch to the ON position.
- Use a small wire (paper-clip) to press the service button.
- The display will show the current count (on initial setup, indicated by a "0"), as well as the firing mode; "S" for side-firing, "F" for front-firing.
- When the firing mode indicator fades, connect the USB cable.
- Press the service button again.
- The display will now indicate that the RX unit is now in CONFIG mode, and is ready for programming.
- Refer to your PC-TB12 manual for information on programming.
» TX Unit - Watch Video
- Turn the TX unit on by sliding the power switch to the ON position.
- Connect the USB cable.
- Use a small wire (paper-clip) to press the service button.
- The LED indicator will illuminate, verifying that the unit is now in CONFIG mode and ready for programming.
- Refer to your PC-TB12 manual for information on programming.
|
